Plastic enclosure for the P4.
Includes front cutout for LEDs, lightpipe, screws, rubber feet, and rear cutouts for NICs & power jacks.
Optional suspension bracket for wall mounting is also available.
Technical Details
Mechanical
Dimensions: 150 x 100 x 45 mm (W x D x H)
Weight : 166g
Protection class: IP40
Operating temperature: -10°C ~ +60°C
Colours: off-white and dark grey
Material: flame-resistant ABS UL94V-0
Assembly
Enclosure kit includes:
1 x bottom base
1 x top cover
1 x CNCed front panel
1 x CNCed rear panel
1 x lightpipe
3 x M2.3 self tapping screws
4 x M2.5 self tapping screws
4 x rubber feet
Steps:
- Place the base on a flat surface
- Orientate the base so the printing is readable and the base front and rear panel slots are top and bottom:
- Align the PCB with the base's standoffs such that the LEDs are at the top, ethernet connectors at the bottom
- Attach the PCB to the base using 3 x M2.3 screws
- Install the lightpipe over the LEDs by aligning its three pegs with the PCB holes. It should point outwards
- Loosely install the front and rear panels in the base slots angled 45 degrees, then raise to vertical position over the parts
- Slide over the top cover, aligning the front and rear panels into its slots
- Once all the panels join tightly, turn over and secure the base and cover with 4 x M2.5 screws
- Install the 4 x rubber feet in the screw holes