Plastic enclosure for the P2.

Includes front cutout for LEDs, lightpipe, screws, rubber feet, and rear cutouts for NICs & power jacks.
Optional suspension bracket for wall mounting is also available.

Technical Details


Dimensions: 100 x 100 x 35 mm (W x D x H)
Weight : 97.1g

Protection class: IP40
Operating temperature: -10°C ~ +60°C

Colours: off-white and dark grey

Material: flame-resistant ABS UL94V-0


Enclosure kit includes:

  1 x bottom base
  1 x top cover
  1 x CNCed front panel
  1 x CNCed rear panel
  1 x lightpipe
  4 x M2.3 self tapping screws
  4 x M2.5 self tapping screws
  4 x rubber feet


  1. Place the base on a flat surface
  2. Orientate the base so the printing is readable and the base front and rear panel slots are top and bottom:
  1. Align the PCB with the base's standoffs such that the LEDs are at the top, ethernet connectors at the bottom
  2. Attach the PCB to the base using 4 x M2.3 screws
  3. Install the lightpipe over the LEDs by aligning its three pegs with the PCB holes. It should point outwards
  4. Loosely install the front and rear panels in the base slots angled 45 degrees, then raise to vertical position over the parts
  5. Slide over the top cover, aligning the front and rear panels into its slots
  6. Once all the panels join tightly, turn over and secure the base and cover with 4 x M2.5 screws
  7. Install the 4 x rubber feet in the screw holes